Sony bdp-s550 service manual

Service Manual, Paper Manual. Related products. DIY Do-It-Yourself manuals are made for homeowners and handymen who have mechanical abilities but can use a little training in repairing certain appliances. It is only to be used along with the service manual not as a replacement for it as it applies to the appliance type, not the specific model and will go into more details on repairing the appliance. Look for parts which, though functioning, show obvious signs.

Check the line cord for cracks and abrasion. Recommend the. Check leakage as described below. After correcting the original service problem, perform the following safety checks before releasing the set to the customer:. AC voltmeter 0. To Exposed Metal Parts on Set. Using an AC voltmeter to check AC leakage.

Unleaded solder Boards requiring use of unleaded solder are printed with the lead- free mark LF indicating the solder contains no lead. Caution: Some printed circuit boards may not come printed with the lead free mark due to their particular size. Unleaded solder has the following characteristics. Ordinary soldering irons can be used but the iron tip has to be. Soldering irons using a temperature regulator should be set to. Caution: The printed pattern copper foil may peel away if the.

CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radia- tion exposure. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Front Chassis Block Rear Panel Block Switching Regulator BD Drive MB Board Circuit Boards Location DSP Block Diagram IT Block Diagram Frame Schematic Diagram Schematic Diagram Printed Wiring Board Side A Printed Wiring Board Side B Printed Wiring Board Exploded Views Panel Section Main Chassis Section Electrical Parts List Refer to page 2.

Remove the top panel assy. Refer to page 3. Remove the top shield. Refer to page 4. Insert a clip in the hole of a drive and open a tray. Note: Use a clip of about 1. Lead pin dressing method change. From top side. Harness DM bending height. Less than Heat-sink height. Need distance: Over 5 mm. Actual: Around 12 mm after ben.

Page of Go. Random: DSC-W90 serv.