Symbol pdt 1100 manual

Users can capture data from 40 mil barcodes at distances up to 22 in. The practical design offers two ways to capture bar code data: from two easy-to-reach side-mount triggers or from the top- mounted M1 and M2 keys, which can be programmed as bar code scanning triggers.

Skip to main content. David E. Spence, Inc. Search form Search. Symbol PDT Category: Data Collection Terminals. Selecting ON for System Status displays the icon, which indicates the keys on the keypad are shifted. Activating this function may increase the frequency of scanning errors. Page 59 3. Setting Communications Environments After the PDT is initialized, the interface port and communications parameters are set as listed in the default tables below. Do not access them unless necessary.

Page 61 System Mode Optical Parameters To set communications parameters for the optical interface: 1. Select each of the following: a.

Press 1 to select the transmission speed. Press 3 to select the communications protocol option. Select one of the following using the numeric keys or F5 and F6 keys. Page 63 System Mode Connector Parameters To set the communications parameters for the direct-connect interface: 1. Select one of the following options using the numeric keys or F5 and F6 keys. Note: If the IR protocol is selected, the parity bit, character length, and stop bit length settings are ignored.

Page 65 3. Page Testing M1 through M4 keys. Testing The PDT terminal conducts tests of all systems upon initialization. To perform a system test: 1. Select 5:TEST on the system menu. Page 68 The following sections explain each test. To stop this test while in progress, turn the power off, then on. Page 71 To select the optical interface test: 1. During the test, the screen indicates the test is running.

If an error occurs, the slave PDT beeps three times and displays the following screen. Page 73 System Mode 3. When the test is complete, the PDT beeps once and displays the following screen.

The checker pattern shown below appears and the decode LED turns off. Press ENT. The checker pattern is reversed. An outline with a width of one dot appears. The fine checker pattern appears. Page 75 Font size standard or small depends upon the setting made previously. Page Chapter 5. Table Service Life of the Battery Due to normal wear and tear, the NiMH battery gradually deteriorates and the service period becomes shorter, even if the battery is fully charged.

Turn on the CRD Place the PDT with the battery loaded in the cradle. This indicates that charging is complete. Power on the CRD Remove the battery pack from the PDT terminal and insert it into the battery pack slot. After discharge, the battery begins charging.

One slot has discharge capability. Figure Figure show the front and back of the CRG Blinks when power supply is faulty.

Blinks about every 2 seconds during trickle charging. Insert the battery pack in a charging slot. Battery Pack Battery Pack in Charger 3. Charging completes after about 10 hours. This allows the memory backup source integrated into the PDT to charge. This message means that the batteries will expire soon. Contact your systems administrator for instructions.

PDT Table Troubleshooting the PDT Problem Power switch is off. Turn power switch on. The maximum usable length of a symbol at any given range is shown in Table A Page 99 40 mil 55 mil Page Bar Code Specifications 0.

Error Codes Code Description Normal end. Filename entered in the wrong format. Page 38 The correct DLL is not found. The IR device does not support the designated transmission speed. Any other error has occurred. Please take a moment to fill out this questionaire and fax this form to: , or mail to: Symbol Technologies, Inc.

Print page 1 Print document 42 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account? Sign up! Restore password. Upload manual.